Canadian Aviation Regulations

201.10 (1) Subject to subsections (4) and (5), the manufacturer of an appliance or a part — including a part approved through the issuance of a part design approval — shall place on it, in the manner specified in subsection 201.05(2), the following identification information:

• (a) the name, trademark or symbol identifying the manufacturer and, if the manufacturer is an entity, its legal name;

• (b) the manufacturer’s approval number; and

• (c) the part number of the appliance or part.

(2) Subject to subsections (4) and (5), the manufacturer of an appliance or a part for which a Canadian Technical Standard Order (CAN-TSO) design approval has been issued under section 521.109 shall place on it, in the manner specified in subsection 201.05(2), the following additional identification information:

• (a) the manufacturer’s address;

• (b) the name, type or model designation of the appliance or part, if any;

• (c) the serial number or the date of manufacture of the appliance or part;

• (d) the letters “CAN-TSO” followed by the applicable CAN-TSO number; and

• (e) any additional markings required by the applicable CAN-TSO.

(3) Subject to subsections (4) and (5), the manufacturer of an appliance or a part for which a type certificate has been issued by the Minister shall place on it, in the manner specified in subsection 201.05(2), the following additional identification information:

• (a) the manufacturer’s address;

• (b) the name, type or model designation of the appliance or part, if any;

• (c) the serial number or the date of manufacture of the appliance or part; and

• (d) the type certificate designation or a reference to the applicable standard of airworthiness.

(4) The manufacturer of an auxiliary power unit shall, in the manner specified in subsection 201.05(2), place the identification information specified in subsection (1) on the unit in an accessible location where it is not likely to become damaged, destroyed, lost or detached during normal operation or in an accident.

(5) If an appliance or a part is too small or if it is otherwise impractical to place on it some or all of the information required by subsection (1), (2) or (3), the information that cannot be placed on the appliance or part shall be placed on its container or on the authorized release certificate referred to in section 561.10 of Standard 561 — Standard for Approved Manufacturers.